Loading…
Name ID Label Description Type Access Class
dig_comm_fault_code 40E6 Comm Fault ind. This fault setting applies to Modbus on RS485 and the display. Downscale: Hold process variables at values that are less than the Lower Sensor Limits and stop totalizing. Upscale: Hold process variables at values that are greater than the Upper Sensor Limits and stop totalizing. Not-a-Number: Set all process variables to IEEE NaN. IntZero-All 0: Set all process variables to 0. IntZero-Flow 0: Set flow rate to 0. None: Process variables displayed as measured (NOTE: Use alternative method to detect fault conditions when NONE is selected) R/W Enum 12
ao_1_fault_level 40E2 mA1 Fault Value This parameter allows you to select the lower or upper mA output level that will indicate a fault condition. The range is 1.0 to 3.6 mA for downscale or 21.0 to 24.0 for upscale. R/W Float 64
fo_fault_level 40E5 FO Fault Value This parameter allows you to select the upper frequency output level that will indicate a fault condition. The maximum value is 15000 Hz. R/W Float 64
ma_1_cutoff 402A PV AO cutoff The mass or volume flow rate below which a milliamp output representing flow indicates zero flow. R/W Float 8
cutoff_code 40EB Cutoff typ R/W Index 4096
tempcal 40EC Temp cal factr A 14-character factor that describes the slope and offset of the linear output representing flow tube temperature. R/W ASCII 32
temp_for_cal 40ED Ref temperature User-entered temperature for the purpose of performing an on-line temperature calibration. R/W Float 4096
density_for_cal 40EE R/W Float 4096
point_code 40EF R/W Unsigned 4096
densityfd_for_cal 40F0 R/W Float 4096
Name ID Label Description Type Access Class