变量名称： error_code

变量ID： 0x41E6

变量标签：

变量描述：

变量处理： 读/写

变量分类： 本地

变量长度： 1

变量数据类型： 枚举

变量枚举值	变量枚举文本
0x0001	Mass Flow Mass flow rate > 1.3x nominal flow. (Light)
0x0002	Zero Error Flow rate at zero adjust too high. (Light)
0x0003	Totaliser Overflow Mass totaliser. (Light)
0x0004	Not Used
0x0005	Temperature Outside operating range. (Light)
0x0006	Sensor A Voltage signal too low. (Severe)
0x0007	Sensor B Voltage signal too low. (Severe)
0x0008	Ratio A/B Sensor signals too different. (Severe)
0x0009	DC A Sensor A has a large DC offset. (Severe)
0x000A	DC B Sensor B has a large DC offset. (Severe)
0x000B	Not Used
0x000C	Sampling PLL out of range. (Severe)
0x000D	Not Used
0x000E	ROM Defaults EEPROM checksum error. (Severe)
0x000F	Not Used
0x0010	EEPROM Unable to save data. (Fatal)
0x0011	NVRAM Checksum error Previous data lost. (Severe)
0x0012	NVRAM Cycles NVRAM used up. (Light)
0x0013	Power Fail Main supply has been switched off. (Light)
0x0014	Watchdog System error or power supply drop-off. (Severe)
0x0015	Not Used
0x0016	Temperature Custody Op. temp. has drifted too much. (Light)
0x0017	Strain Strain out of operating range. (Fatal)
0x0018	Current Outp. I1 Sat. Change output range. (Output)
0x0019	Freqency Outp. P Sat. Change output range. (Output)
0x001A	Process Alarm Limit check exceeded. (Output)
0x001B	Current Outp. I2 Sat. Change output range. (Output)
0x001C	Current Outp. I3 Sat. Change output range. (Output)
0x001D	Communication Error (Severe)
0x001E	System Error Front end / back end. (Severe)

变量显示格式：

变量编辑格式：

变量单位：

变量最大值： N/A

变量最小值： N/A

变量读取命令列表

无

变量写入命令列表

无