Loading…

方法名称： methodManualStop

方法ID： 0x4025

方法标签： Manual Stops

方法描述： This method is used to set manual stops.


  • {
  • char nbr;
  • char status[3];
  • char prevMode;
  • int result;
  • send(249, status); if( status[0] != 0 ) { display_response_status(249, status[0]); DELAY(3,"|en|Procedure aborted \nTry Again."); process_abort();; }; if( (_ivar_value(16385) != 0) ) { ACKNOWLEDGE("|en|WARNING. This procedure requires to enter setup mode and will result in LOSS of PROCESS CONTROL. Do you wish to proceed ?"); PUT_MESSAGE("|en|Changing mode to Setup"); _add_abort_method(16390); _iassign(16684,(0)); send(135, status); if( status[0] != 0 ) { display_response_status(135, status[0]); DELAY(3,"|en|Procedure aborted \nTry Again."); process_abort();; }; nbr=0; do { nbr += 1; if( nbr == 10 ) { DELAY(3,"|en|Procedure aborted \nTry Again."); process_abort();; }; send(249, status); } while( _ivar_value(16385) != 0 ); };
  • ACKNOWLEDGE("|en|WARNING. This procedure will MOVE the valve. This will result in LOSS of process CONTROL. DO YOU WISH TO CONTINUE?");
  • do
  • {
  • result = SELECT_FROM_LIST("|en|Set Manual Stop Position:",
  • "|en|Low;High;Exit");
  • if (result != 2)
  • {
  • _iassign(16683,(3));
  • if( ((result == 1) && (_ivar_value(16414) == 0)) ||
  • ((result == 0) && (_ivar_value(16414) == 1)) )


请登录以获得完整内容