Loading…

方法名称： relay_adjust_method

方法ID： 0x4332

方法标签： Relay Adjust

方法描述：


  • {
  • float qa, qb, qc, qd, qe, mpp; int q, q0, q1, q2, q3, q4, q5, q6, q7, q8; char S[3];
  • int c, i;
  • long ids[2];
  • _set_device_status(0xFF,0);
  • _set_xmtr_device_status(0xFF,0);
  • _set_all_resp_code(1);
  • _set_resp_code((8),0);
  • send(151,S); if(_ivar_value(16804)>2) { ACKNOWLEDGE("|en|The DD revision is not compatible with the firmware in the device.\nContact your Fisher sales office for an upgrade to your DD."); return; };
  • send_trans(129,0,S); _vassign(16452,16427); save_values(); if(1==_ivar_value(167)) { ACKNOWLEDGE("|en|Protection must be disabled to perform this operation."); process_abort(); } if((_ivar_value(16427))) { if(((_ivar_value(16465) & 0x01C0) == 0x0100)) { _get_dev_var_value(("|en|WARNING! Output will not track input and the SIS safety function will be disabled when Instrument Mode is Out of Service."),0,16452); } else { _get_dev_var_value(("|en|WARNING! Output will not track input when Instrument Mode is Out of Service."),0,16452); } save_values(); if(_ivar_value(16452)>0) { ACKNOWLEDGE("|en|Instrument Mode is still In Service."); process_abort(); } else { send_trans(130,6,S); } } send_trans(129,0,S); if((1==_ivar_value(16472)) || (5==_ivar_value(16472))) { if(1==_ivar_value(16472)) { ACKNOWLEDGE("|en|Access restricted\n\nInstrument was set to 'Out of Service' by a secondary master."); } else { ACKNOWLEDGE("|en|Access restricted\n\nInstrument was set to 'Out of Service' by a primary master."); } process_abort(); } _add_abort_method(17167); DELAY(1,"|en|Please wait...");
  • send(138,S); send_trans(129,0,S); if(((_ivar_value(16790) & 0x31) > 0) || (_ivar_value(10098) == 0)) { send_trans(142,8,S); send_trans(142,1,S); send_trans(157,0,S); if(1 != _ivar_value(167)) { _iassign(16622,(0)); save_values(); send_trans(130,75,S); } if((_ivar_value(171) == 0)) _iassign(16453,(2)); else _iassign(16453,(3)); save_values(); send_trans(130,7,S); send_trans(129,0,S); DELAY(1,"|en|Please wait..."); };
  • c = 1;
  • send_trans(129,35,S);
  • if(1 - SELECT_FROM_LIST("|en|WARNING! Relay adjust will cause the valve to move from its last set point.","|en|Continue;Exit"))
  • {
  • while(((_ivar_value(16530) & 0x01) > 0) && ((_ivar_value(16532)&0x1B) > 0))


请登录以获得完整内容