Loading…
Loading…
| 名称 | ID | 标签 | 描述 | 类型 | 源代码 |
|---|---|---|---|---|---|
| End_Alignment_method | 4068 | 中止返回正常 | msrc_UNKNOWN | 详细信息 | |
| Start_Alignment | 4069 | Start alignment | msrc_UNKNOWN | 详细信息 | |
| Abort_Cal_method | 406A | 中止返回正常 | msrc_UNKNOWN | 详细信息 | |
| Reset_Alarms | 406B | Reset latched alarms | msrc_UNKNOWN | 详细信息 | |
| Rstore_factory | 406C | Restore factory defaults | msrc_UNKNOWN | 详细信息 | |
| Zero_Cal | 406D | Zero cal | msrc_UNKNOWN | 详细信息 | |
| Span_Cal | 406E | Span cal | msrc_UNKNOWN | 详细信息 | |
| Stop_Alignment | 406F | Stop alignment | msrc_UNKNOWN | 详细信息 | |
| response_test | 4070 | Response test | msrc_UNKNOWN | 详细信息 | |
| event_log_method | 4071 | Event log | Retrieves stored events. The most recent event is shown first. Recorded events include Blocked Optics, warm up, zero drift, low alarm & high alarm. | msrc_UNKNOWN | 详细信息 |
| cal_log_method | 4072 | Calibration log | Retrieves stored calibration events. The most recent calibration event is shown first. Calibrations are recorded as zero only cal, cal OK & cal failed. Cal OK indicates that both zero and span were completed. | msrc_UNKNOWN | 详细信息 |
| change_password | 4073 | Change password | msrc_UNKNOWN | 详细信息 | |
| transmitter_loop_test | 1023 | 回路测试 | 回路测试——允许用户将选择的模拟量输出手动调节至选择的常数输出值。 | msrc_UNKNOWN | 详细信息 |
| leave_fixed_current_mode | 1003 | 退出固定电流模式 | 退出固定电流模式——使选择的模拟量输出退出输出为常数值的模式，使输出返回输出跟踪输入的模式。 | msrc_UNKNOWN | 详细信息 |
| return_to_normal | 1016 | 中止返回正常 | msrc_UNKNOWN | 详细信息 | |
| warning_message | 1017 | 设置回路为手动 | msrc_UNKNOWN | 详细信息 | |
| transmitter_dac_trim | 1024 | D/A修正 | 数字到模拟修正——允许对选择的模拟量输出进行标定，在模拟量输出的操作端点有外部参考。 | msrc_UNKNOWN | 详细信息 |
| 名称 | ID | 标签 | 描述 | 类型 | 源代码 |