Loading…
Loading…
| 名称 | ID | 标签 | 描述 | 类型 | 源代码 |
|---|---|---|---|---|---|
| method_master_reset | 406E | Device reset | msrc_UNKNOWN | 详细信息 | |
| method_temp_cal | 4065 | Start Temperature Cal | Temperature calibration. A smart two point temperature calibration can be accomplished by performing temp cal at the lower point first and then at the upper point, the two points separated by at least 20 deg-C. | msrc_UNKNOWN | 详细信息 |
| method_one_point_cal | 4064 | Start Cond/Conc. Cal | msrc_UNKNOWN | 详细信息 | |
| method_reset_cal | 406C | Reset PV,temp Cal | Reset the process and temperature sensor calibration data to the values set at the factory | msrc_UNKNOWN | 详细信息 |
| method_cal_exit | 4096 | Exit from calibration | msrc_UNKNOWN | 详细信息 | |
| RunTCRecognition | 4031 | Run TC Recognition | On demand scan for temperature sensor type could be performed using this procedure. Normally, the device scans for temperature sensor at power up and when TC type is changed from Manual to Auto or Auto Sol. This procedure lets the user run the scan when the temperature sensor has been changed. | msrc_UNKNOWN | 详细信息 |
| reset_configChangedFlag | 406F | Reset Configuration Changed Flag | Reset the device Configuration Changed flag | msrc_UNKNOWN | 详细信息 |
| PV_range_post_edit_method | 4098 | PV Range Units Warning | Warning | msrc_UNKNOWN | 详细信息 |
| post_edit_diagSim_warning | 4099 | Diag Simulation warning | msrc_UNKNOWN | 详细信息 | |
| loop_test | 1002 | 回路测试 | 回路测试——允许用户将选择的模拟量输出手动调节至选择的常数输出值。 | msrc_UNKNOWN | 详细信息 |
| dac_trim | 1004 | D/A修正 | 数字到模拟修正——允许对选择的模拟量输出进行标定，在模拟量输出的操作端点有外部参考。 | msrc_UNKNOWN | 详细信息 |
| return_to_normal | 1016 | 中止返回正常 | msrc_UNKNOWN | 详细信息 | |
| leave_fixed_current_mode | 1003 | 退出固定电流模式 | 退出固定电流模式——使选择的模拟量输出退出输出为常数值的模式，使输出返回输出跟踪输入的模式。 | msrc_UNKNOWN | 详细信息 |
| 名称 | ID | 标签 | 描述 | 类型 | 源代码 |