Loading…
Name ID Label Description Type Access Class
rt_sigma 40CD Standard Deviation A unitless value which characterizes the amount of deviation between readings during an Auto Zero operation. R Float 10
fault_index 40CE Output Type R/W Index 4096
LMV_fault_timeout 40D0 Время задержки в случае неисправности This parameter defines the number of seconds for which all outputs will hold their last measured value prior to going to the configured fault state. The default is zero seconds. R/W Unsigned 12
ao_1_fault_code 40D3 Действие сбоя Минимальное значение при измерении: токовые выходы, показывающие поток, переходят на настроенный предел. Максимальное значение при измерении: токовые выходы переходят на настроенный предел. Внутренний ноль: выходы потока показывают нулевой поток. R/W Enum 12
ao_1_fault_level 40D5 Fault Level (Direct) This parameter allows you to select the lower or upper mA output level that will indicate a fault condition. For a 12-20 mA output (Direct), the range is 11.5 to 11.8 mA for downscale or 20.5 to 22.0 for upscale. For a 4-20 mA output (Level-Shifted), the range is 3.0 to 3.6 mA for downscale or 21.0 to 24.0 for upscale. R/W Float 66
ao_1_fault_level_4_20 40D7 Уровень ошибки (изолирующий адаптер) This parameter allows you to select the lower or upper mA output level that will indicate a fault condition. For a 12-20 mA output (Direct), the range is 11.5 to 11.8 mA for downscale or 20.5 to 22.0 for upscale. For a 4-20 mA output (Level-Shifted), the range is 3.0 to 3.6 mA for downscale or 21.0 to 24.0 for upscale. R/W Float 66
dig_comm_fault_code 40D9 Действие сбоя цифровой связи This fault setting applies to Modbus on RS485 and the display. Downscale: Hold process variables at values that are less than the Lower Sensor Limits and stop totalizing. Upscale: Hold process variables at values that are greater than the Upper Sensor Limits and stop totalizing. Not-a-Number: Set all process variables to IEEE NaN. IntZero-All 0: Set all process variables to 0. IntZero-Flow 0: Set flow rate to 0. None: Process variables displayed as measured (NOTE: Use alternative method to detect fault conditions when NONE is selected) R/W Enum 12
density_for_cal 40DE R/W Float 4096
point_code 40DF R/W Unsigned 4096
densityfd_for_cal 40E0 R/W Float 4096
Name ID Label Description Type Access Class