Loading…
Name ID Label Description Type Access Class
Turbulence 4025 Turbulence Increase choice if Quality value is consistently < 20. R/W Enum 2048
RateChange 4026 Rate of Change Select the Maximum rate of change of the level surface (rising or falling). R/W Enum 2048
Foam 4027 Foam Increase choice if Quality value is consistently < 20. R/W Enum 2048
TankTop 4028 Tank Top Select the metallic tank top structure (choose Other for non-metalic tanks). R/W Enum 2048
TankHeight 4029 Tank Height Distance from the bottom to the top of tank. R/W Float 2048
TrimLevel 402A Trim Level Trim Level is an offset value to be used to force the transmitter to output the exact Level. This should only be used after all parameters have been entered correctly, Tank Height and Sensor Offset have been confirmed accurate, and it has been confirmed that the transmitter is tracking the correct level target. R/W Float 2048
BlockingDistance 402B Blocking Distance Blocking Distance defines an area near the antenna where reflections cannot be measured effectively due to antenna ringing. It is measured from the sensor reference point (bottom of NPT thread or flange face, top of BSP thread). Level reading will never be higher than level corresponding to Blocking Distance value. Do not allow liquid onto the antenna. R/W Float 2048
Initials 402C Date/Time/Initials When and by whom calibration was performed. R/W PackedAscii 2052
EnteredPassword 402D Enter Password Password is required for adjusting Factory Settings. W Unsigned 2052
user_password 402E New User Password User password required to change parameter settings from keypad. R/W Unsigned 2048
Name ID Label Description Type Access Class