Loading…
名称 ID 标签 描述 类型 访问 分类
lg_probe 409B Probe Length This value has to equal the exact real length of the probe. The only situations for changing this value is if the probe has been changed. 读/写 浮点 2048
DeadZone 409D Dead Zone Measurements near the flange may not be precise or reliable. Therefore, the "Dead Zone" prevents measurements in this area. The minimum value is equal to that shown in Table x (refer to "Installation and Operating Instructions" manual). Measurement may not be precise in an area less than this recommended value. The factory default value is 0.40 m. 读/写 浮点 2048
DetectionDelay 40AC Detection Delay This function forces the instrument not to analyze reflections in a zone immediately below the flange. The detection delay allow to modify the size of this zone 读/写 浮点 2048
end_probe_distance 4047 Cal. Probe Length 读/写 浮点 2048
userCode 4013 Code 1 写 ASCII 2052
OldUserCode 4012 Coded Code 1 读 ASCII 2052
nPoint 401B Number of points CAUTION! 1. If the number of points is changed (with or without changes of the table contents), the user should ignore the first possible error response after pressing APPLY (TABLE NOT MONOTONOUS happened writing NUMBER OF POINTS), change the number of points again to desirable one (i.e. reenter exactly the same value) and again press APPLY. 2. If the number of points is preserved but some table items are changed, the user should press APPLY (thus transferring changed items to device), then reenter the number of points (as above) and press APPLY again - otherwise the updated point(s) will be in play only until the first power reset. 读/写 无符号 16
point_number 4015 读/写 索引 4096
point_level 40D9 读/写 浮点 16
point_volume 40DA 读/写 浮点 16
名称 ID 标签 描述 类型 访问 分类