Variable Name: RBActualError1

Variable ID: 0x40A9

Variable Label: actual error 1

Variable Help:

Variable Handling: R

Variable Class: Dynamic | Device

Variable Size: 2

Variable DataType: Enum

Variable Enum Value	Variable Enum Text
0x006F	A111: electronics defect
0x0070	A112: electronics defect
0x0071	A113: electronics defect
0x019C	A412: electronics defect
0x019D	A413: electronics defect
0x019E	A414: electronics defect
0x019F	A415: electronics defect
0x01A0	A416: electronics defect
0x01A1	A417: electronics defect
0x01A2	A418: electronics defect
0x0194	A404: electronics defect
0x0195	A405: electronics defect
0x0197	A407: electronics defect
0x0198	A408: electronics defect
0x0199	A409: electronics defect
0x019A	A410: electronics defect
0x019B	A411: electronics defect
0x0190	A400: measured capacity too big
0x0193	A403: measured capacity too small
0x01A4	A420: wrong probe
0x01A5	A421: electronics defect
0x01A6	A422: electronics defect
0x01A7	A423: electronics defect
0x01A8	A424: electronics defect
0x01FF	W511: no factory calibration ch1
0x01A9	W425: Insulation fault
0x01AC	A428: Alarm insulation
0x01AD	W429: prooftest active
0x0072	A114: electronics defect
0x01AA	A426: electronics defect
0x01AB	A427: electronics defect
0x0065	A101: checksum error general reset + new calibr.required
0x0067	W103: initialising - please wait
0x0099	W153: initialising - please wait
0x0461	A121: Current output 1 not calibrated
0x0462	A121: Current output 1 not calibrated
0x00AB	A171: electronics defect
0x006E	A110: checksum error general reset + new calibr.required
0x009B	A155: electronics defect
0x00A4	A164: electronics defect
0x0073	A115: electronics defect
0x006A	A106: downloading please wait
0x0074	A116: download error repeat download
0x0644	A604: calibration level 1 failure check calibr.
0x0687	A671: linearisat. failure level 1
0x0693	A683: current 1 turn down fault check calibr.
0x0694	A683: current 1 turn down fault check calibr.
0x067E	W662: high sensor temperatur
0x0691	W681: current 1 out of range
0x064B	W611: less than 2 linearisation points for level 1
0x0641	W601: linearisation curve steps incorrec level 1
0x0709	W801: simulation level 1 on
0x070E	W806: simulation current1 on
0x01F7	W503: wrong sensor type
0x01AE	W430: sensor data not compatible
0x0000	0

Variable Display Format:

Variable Edit Format:

Variable Unit:

Variable Max: N/A

Variable Min: N/A

Variable Read Command List

None

Variable Write Command List

None