Loading…
Loading…
| Name | ID | Label | Description | Type | Source |
|---|---|---|---|---|---|
| nd_stop_prestage_trim_method | 408A | Stop prestage trim | Emergency stop of prestage trim | msrc_UNKNOWN | Details |
| nd_prestage_trim_method | 4080 | Trim prestage unit | Automatic trim of prestage unit | msrc_UNKNOWN | Details |
| ret_from_max_press_mode | 408B | W | msrc_UNKNOWN | Details | |
| nd_warn_cal_and_trim | 4058 | Warn | msrc_UNKNOWN | Details | |
| nd_event_log_display_method | 4059 | Event log | View event log | msrc_UNKNOWN | Details |
| nd_pressure_sensor_calib_method | 405A | Pressure sensor | Pressure sensor module calibration | msrc_UNKNOWN | Details |
| nd_position_sensor_calib_method | 405B | Position sensor | Position sensor module calibration, temperature compensation and identification | msrc_UNKNOWN | Details |
| nd_custom_flow_linearization_method | 405C | Custom linearization | Sets customized travel curve of the control valve to linearize the relationship between valve travel setpoint and flow | msrc_UNKNOWN | Details |
| nd_temperature_sensor_calib_method | 405D | Temp measurement | Temperature ADC zero calibration of the component board module | msrc_UNKNOWN | Details |
| nd_input_signal_calib_method | 405E | Input signal | Input signal ADC zero and span (4-20mA) calibration of the component board module | msrc_UNKNOWN | Details |
| nd_stop_travel_auto_calib_method | 405F | Stop calibration | Emergency stop of calibration | msrc_UNKNOWN | Details |
| nd_travel_auto_calib_method | 4060 | Auto calib travel | Automatic calibration of control valve travel against mechanical travel limits corresponding to 0-100% input signal | msrc_UNKNOWN | Details |
| advise_to_send | 4061 | Unit code advise | msrc_UNKNOWN | Details | |
| change_nd_sn | 4062 | Set ND800 S/N | Stores the serial number of the ND800 valve controller into the nonvolatile memory of the ND800. Must be set when component board is replaced | msrc_UNKNOWN | Details |
| nd_reset_valve_cntrs | 4063 | Reset valve cntrs | Resets the valve counters to zero | msrc_UNKNOWN | Details |
| nd_reset_actuator_cntrs | 4064 | Reset act cntrs | Resets the actuator counters to zero | msrc_UNKNOWN | Details |
| nd_pos_transmitter_calib_method | 4065 | Position transmitter | Position transmitter DAC zero and span calibration | msrc_UNKNOWN | Details |
| return_to_normal | 1016 | Aborting return to normal | msrc_UNKNOWN | Details | |
| warning_message | 1017 | Set loop to manual | msrc_UNKNOWN | Details | |
| leave_analog_fixed_current_mode | 1009 | Leaving fixed crnt mode | Leaving Fixed Current Mode- Takes the selected Analog Output out of a mode where the output was a constant value, and returns the output to a mode where the output then tracks the input | msrc_UNKNOWN | Details |
| Name | ID | Label | Description | Type | Source |