Loading…
Loading…
| Name | ID | Label | Description | Type | Source |
|---|---|---|---|---|---|
| Refresh_Echo_Curve | 4123 | Refresh Echo Curve | msrc_UNKNOWN | Details | |
| Refresh_History_table | 4491 | View History | Displays current status and run time as well as a history of most recent faults and warnings. For each event, the run time when the event occurred and the duration of the event are shown. The run time is the time since power up or a history reset. The table of history events displays the most recent event at the top with successively preceding events in descending order. | msrc_UNKNOWN | Details |
| HistReset_method | 40FC | Reset History | Clears entries in Status History and resets the run time to zero. | msrc_UNKNOWN | Details |
| SZAlarmReset_method | 40F1 | SZ Alarm Reset | Clear a latched Safety Zone Alarm | msrc_UNKNOWN | Details |
| TempReset_method | 40F6 | Reset Temperatures | Reset the maximum and minimum temperatures measured in the electronics compartment to the present temperature. | msrc_UNKNOWN | Details |
| AutoTargCalib_method | 40F8 | Auto Target Calib | Captures time-of-flight to target on steam probe types at room ambient. | msrc_UNKNOWN | Details |
| abort_from_targ_cal | 411D | Targ Cal Abort | msrc_UNKNOWN | Details | |
| reset_config_changed | 4509 | Reset Config Chgd | Resets the Configuration Changed bit in the Device Status | msrc_UNKNOWN | Details |
| transmitter_dac_trim | 1024 | D/A Trim | Digital to Analog Trim- Allows the calibration of a selected Analog Output with an external reference at the operating endpoints of the Analog Output | msrc_UNKNOWN | Details |
| read_dac_trim_values | 452A | Read DAC trim values | Reads the values for DAC trim | msrc_UNKNOWN | Details |
| return_to_normal | 1016 | Aborting return to normal | msrc_UNKNOWN | Details | |
| warning_message | 1017 | Set loop to manual | msrc_UNKNOWN | Details | |
| leave_fixed_current_mode | 1003 | Leaving fixed crnt mode | Leaving Fixed Current Mode- Takes the Analog Output out of a mode where the output was a constant value, and returns the output to a mode where the output tracks the input | msrc_UNKNOWN | Details |
| transmitter_loop_test | 1023 | Loop Test | Loop test- Allows the User to manually manipulate the Analog Output to a selected constant output value | msrc_UNKNOWN | Details |
| Name | ID | Label | Description | Type | Source |