Loading…
Loading…
| Name | ID | Label | Description | Type | Source |
|---|---|---|---|---|---|
| func_gen_delay | 4021 | Function Generator Write Delay | msrc_UNKNOWN | Details | |
| load_standard_config | 4025 | Load Std Config | Load Standard Configuration - Instructs the transmitter to change all the configuration variables in the transmitter's memory to the standard values set by the manufacturer. This puts the transmitter into a known good state. Existing user defined values will be lost but can be re-entered. | msrc_UNKNOWN | Details |
| xmtr_reset | 4026 | Reset Transmitter | Reset Transmitter - Instructs the transmitter to generate a hardware reset. The result is similar to the effects of briefly interrupting power to the transmitter. The analog output will go to the Initialization Mode (Init Mode) value while the transmitter is in the start-up process. This can be used to recover from an error condition if needed. | msrc_UNKNOWN | Details |
| remove_cal_pressure | 4036 | Remove Cal Press | msrc_UNKNOWN | Details | |
| xmtr_cal | 4037 | Two point calib | Two Point Calibration - Calibration procedure where two different pressures are used, typically at or near the Lower Range Value and Upper Range Value of the transmitter. | msrc_UNKNOWN | Details |
| loop_test | 1002 | Loop test | Loop test- Allows the User to manually manipulate the Analog Output to a selected constant output value | msrc_UNKNOWN | Details |
| dac_trim | 1004 | D/A trim | Digital to Analog Trim- Allows the calibration of a selected Analog Output with an external reference at the operating endpoints of the Analog Output | msrc_UNKNOWN | Details |
| scaled_dac_trim | 1005 | Scaled D/A trim | Digital to Analog Scaled Trim- Allows the calibration of the Analog Output with an external reference at the operating endpoints of the Analog Output | msrc_UNKNOWN | Details |
| zero_trim | 1006 | Zero trim | Zero trim- Make the sensor input the new zero input reference | msrc_UNKNOWN | Details |
| leave_fixed_current_mode | 1003 | Leaving fixed crnt mode | Leaving Fixed Current Mode- Takes the Analog Output out of a mode where the output was a constant value, and returns the output to a mode where the output tracks the input | msrc_UNKNOWN | Details |
| return_to_normal | 1016 | Aborting return to normal | msrc_UNKNOWN | Details | |
| warning_message | 1017 | Set loop to manual | msrc_UNKNOWN | Details | |
| send_warning | 1399 | Send warning | Send Warning- Yields a units code notice to the User | msrc_UNKNOWN | Details |
| Name | ID | Label | Description | Type | Source |