Loading…
Name ID Label Description Type Access Class
ao_1_fault_code 408B AO Fault indicator Downscale: Milliamp outputs that indicate flow go to the configured limit, the frequency output equals 0 Hz. Upscale: Milliamp and frequency outputs go to the configured limit. Internal zero: Flow outputs indicate zero flow. R/W Enum 4
fo_fault_code 408F FO Fault indicator Downscale: Milliamp outputs that indicate flow go to the configured limit, the frequency output equals 0 Hz. Upscale: Milliamp and frequency outputs go to the configured limit. Internal zero: Flow outputs indicate zero flow. R/W Enum 4
dig_comm_fault_code 4091 Comm Fault ind. This fault setting applies to Modbus on RS485. Downscale: Hold process variables at values that are less than the Lower Sensor Limits and stop totalizing. Upscale: Hold process variables at values that are greater than the Upper Sensor Limits and stop totalizing. Not-a-Number: Set all process variables to IEEE NaN. IntZero-All 0: Set all process variables to 0. IntZero-Flow 0: Set flow rate to 0. None: Process variables displayed as measured (NOTE: Use alternative method to detect fault conditions when NONE is selected) R/W Enum 4
ao_1_fault_level 408D mA Fault Value This parameter allows you to select the lower or upper mA output level that will indicate a fault condition. The range is 1.0 to 3.6 mA for downscale or 21.0 to 24.0 for upscale. R/W Float 64
fo_fault_level 4090 FO Fault Value This parameter allows you to select the upper frequency output level that will indicate a fault condition. The maximum value is 15000 Hz. R/W Float 64
density_for_cal 4092 R/W Float 4096
point_code 4093 R/W Unsigned 4096
densityfd_for_cal 4094 R/W Float 4096
temp_for_cal 4095 Ref temperature User-entered temperature for the purpose of performing an on-line temperature calibration. R/W Float 4096
cutoff_code 4098 Cutoff typ R/W Index 4096
Name ID Label Description Type Access Class