Loading…
Name ID Label Description Type Access Class
concDampVal 400B Conc damp Damping Value- Damping time constant applied to both the Digital Value representation and Analog Value of the respective Analog Output. The units of this variable are always in seconds. R Float 0
concUpdPeriod_int 4054 Conc Update Period R Unsigned 0
concSerNum 400D Conc snsr s/n Sensor Serial Number- Uniquely identifies the sensor from which the Digital Value representation or Field Device variable is primarily derived. R/W Unsigned 2048
concLTP 400E Conc Lower trim Lower Trim Point- Applied process input at which the last lower trim of the device variable was performed. R Float 0
concUTP 400F Conc Upper trim Upper Trim Point- Applied process input at which the last upper trim of the device variable was performed. R Float 0
concTrimSupport 4010 Conc Trim support Trim Points Supported- Indicates the trim points that are supported by the device variable during a trim procedure. R Enum 0
concMinLTP 4011 Conc Min lower trim Minimum Lower Trim Point- The lowest applied process value that can be used duirng a low trim procedure (ie, no value lower than this will be accepted by the instrument). R Float 0
concMaxLTP 4012 Conc Max lower trim Maximum Lower Trim Point- The highest applied process value that can be used duirng a low trim procedure (ie, no value higher than this will be accepted by the instrument). R Float 0
concMinUTP 4013 Conc Min upper trim Minimum Upper Trim Point- The lowest applied process value that can be used duirng a high trim procedure (ie, no value lower than this will be accepted by the instrument). R Float 0
concMaxUTP 4014 Conc Max upper trim Maximum Upper Trim Point- The highest applied process value that can be used duirng a high trim procedure (ie, no value higher than this will be accepted by the instrument). R Float 0
Name ID Label Description Type Access Class