Loading…
Name ID Label Description Type Access Class
zero_flow_signal 4030 Zero Flow Signal Zero Flow Signal - Probe calibration factor. R/W Float 32
current 4009 PV Loop Valor de salida analógica: Valor que sigue la representación del valor digital, bajo modos de funcionamiento normales R/W Float 66
fault 400A Fault State Fault State - Select how the Analog output of the TA2 will respond if a fault in the instrument is detected. R/W Enum 65
set4mA 40BF 4mA Set Point 4mA Set Point - Enter the 4 mA point using the units of measurement previously selected. R/W Float 64
set20mA 40BE 20mA Set Point 20mA Set Point - Enter the 20 mA point using the units of measurement previously selected. R/W Float 64
percent_range 400B % Output R Float 66
diameter 4031 Pipe ID Pipe Inside Diameter - The flow area must be entered. This is done by either entering the inside diameter of a pipe or the cross sectional area of the pipe or duct. R/W Float 32
area 4032 Flow Area Flow Area - The flow area must be entered. This is done by either entering the inside diameter of a pipe or the cross sectional area of the pipe or duct. R/W Float 32
totalizer_mode 4018 Mode Mode - Enable or Disable the totalizer operation. R/W Enum 32
elapsed_time 4033 Elapsed Time Elapsed Time - Displays the elapsed time in hours since the totalizer was last re-set. R Float 2050
Name ID Label Description Type Access Class