Loading…
名称 ID 标签 描述 类型 访问 分类
MinTemp 403B Min Temperature Minimum temperature measured in the electronics compartment. 读 整型 2051
SZFault 403C SZ Fault State Safety Zone Fault State defines how the Analog Output will respond when the transmitter detects a level within the Safety Zone. Enable fault to ensure safe, reliable high-level readings in critical applications. If Latch 3.6 or Latch 22 is chosen, the unit will remain in alarm until it is manually cleared with the SZ Alarm Reset. 读/写 枚举 65
SZHeight 403D SZ Height Safety Zone Height - Enter a distance that defines a safety zone just below the Blocking Distance. If Safety Zone Fault is enabled, the transmitter will report a fault if the level rises into this zone. 读/写 浮点 2048
SZHysteresis 403E SZ Hysteresis Level must fall this distance below Safety Zone to clear a Safety Zone Fault. Default setting is suitable for most installations. Refer to I & O manual before adjusting. 读/写 浮点 2048
SteamFactor 403F Derating Factor Displayed for diagnostic purposes only. 读 整型 10
TargOperMode 4040 Target Oper Mode Run mode enables automatic compensation. Cal mode allows calibration of target through air; Off mode disables automatic compensation. Default setting is suitable for most installations. Refer to I & O manual before adjusting. 读/写 枚举 8
TargetCalValue 4041 Targ Calib Value Factory parameter, displayed for diagnostic purposes only. 读/写 整型 8
TargetTicks 4042 Target Ticks Displayed for diagnostic purposes only. 读 整型 10
TargetAmpl 4043 Target Amplitude Displayed for diagnostic purposes only. 读 无符号 10
Factory_Param1 4044 HF Cable Remote HF Cable distance. Consult factory for assistance. 读/写 整型 8
名称 ID 标签 描述 类型 访问 分类