Loading…
Loading…
Name | ID | Label | Description | Type | Access | Class |
---|---|---|---|---|---|---|
key_number | 405A | Key number selection | Key number selection | R | ASCII | 2048 |
table_II | 405B | Table II Information | Table II Information | R | ASCII | 2048 |
table_III | 405C | Table III Information | Table III Information | R | ASCII | 2048 |
table_IV | 405D | Table IV Information | Table IV Information | R | ASCII | 2048 |
low_flow_cutoff_mode | 405E | Low Flow Cutoff Mode | Allows selecting User configurable single Breakpoint mode or Dual slope mode. When 'User configurable' option is selected it allows the user to specify a single breakpoint as the low flow cutoff point. When 'Dual Slope' is selected, device uses a dual slope formula to determine the low flow cutoff point.When 'Zero Flow' is selected,it sets analog output to 4mA when square root / flow is below user defined flow cutoff value. | R/W | Enum | 2048 |
low_flow_cutoff_brkpt | 405F | Low Flow Cutoff Brkpt(User Config) | User specified single breakpoint as the low flow cutoff point when the Transfer Function is set to Square Root and Low flow cutoff mode is 'User configurable' or 'Zero Flow'. Range is 0 to 25.0 %Flow. | R/W | Float | 2048 |
sqrt_flow_val | 4060 | Square-Root Flow Value | Square-root flow value of Low flow cutoff method-2 | R | Float | 2050 |
install_date | 4061 | Install Date | Transmitter installation date in MM/DD/YYYY format.This is one time writable parameter. | R/W | HartDate | 2048 |
time_in_service | 4062 | Time In Operation | Gives the total time of the device being operational | R | Unsigned | 2048 |
sensor_time_in_service | 4063 | Sensor Time In Operation | Gives the total time of the sensor being operational | R | Unsigned | 2048 |
Name | ID | Label | Description | Type | Access | Class |