Loading…
名称 ID 标签 描述 类型 访问 分类
fManualSig 40A9 set valve pos in mA Manual valve setpoint in mA. 读/写 浮点 4096
cMode 4007 mode SVI II modes can be normal,manual,setup (calibrate configuration,diagnostic) or failsafe. 读 枚举 10
bConfigFlags1 4040 setup SVI II configuration information,actuator sense and bumpless tranfert activation. 读/写 位枚举 8
bConfigFlags2 4047 limits and cam Status for low/upper limits, tight shutoff, cam characteristic (Default configuration is Linear)and re-zeroed pressure sensor if available. 读/写 位枚举 8
bConfigFlags2_bis 406C cam cam used in the SVI II:relationship between flow capacity (Cv) and percentage opening of the valve.Several cams are available:linear, =%50 , =%30 , quick opening coeff 50 , custom. 读 ASCII 4096
bConfigFlags2_third 406D options Status for low/upper limits,tight shutoff and re-zeroed pressure sensor if available. 读/写 位枚举 4096
bConfigFlags3 4048 buttons define lock level for SVI II buttons to avoid unintended modifications. 读/写 枚举 8
bConfigFlags4 4049 SP This option determines whether the controller setpoint will be in local ,local only , remote or last mode on start up. 读/写 位枚举 8
fTSLimit 404A Tight Shutoff Threshold for tight shutoff: when selected, if the input signal would position the valve below the tight shutoff value, full supply or atmosphere pressure is supplied to the actuator to close the valve with full seating force. Value between -1% and 20%. 读/写 浮点 8
fLPosLimits 404B Lower Limit The SVI II allows the user to establish software limit stops.The control functions will NOT allow the valve position to be lower than the lower position limit.However this option DOES NOT PROVIDE MECHANICAL STOPS for the valve.During a electrical or air failure the valve will go to the fail safe position without regard to the software limit stops.The manual position full closed or full open will similary ignore limit stops. 读/写 浮点 8
名称 ID 标签 描述 类型 访问 分类