Loading…
Loading…
Name | ID | Label | Description | Type | Access | Class |
---|---|---|---|---|---|---|
ucNetzfrequenz | 40A4 | Line frequency | Selection of the line frequency of the flowmeter primary was calibrated. Selection 50/60 Hz only available for Older Models. | R/W | Enum | 2048 |
ucStartUpKommuService | 40A6 | Startup Commu. | With a TTL-Signal the communication type HART or ASCII can be selected of the service plug for the connection. | R/W | Enum | 2048 |
ucTestImpulsausgangEin | 40A8 | Startup Commu. | Function test for the pulse output. | R/W | Enum | 2048 |
ucIoutArt | 40AA | Current output | Selection of the current output range. For HART-Protocol always 4-20 mA. | R/W | Enum | 2048 |
ucKommuServiceStecker | 40AC | Com. Type TTL | The choice of the occupancy of the communication for the service plug can be returned. Communication HART- TTL or ASCII-TTL can be switched over to on display operate function. | R/W | Enum | 2048 |
ucImpulsZustand | 40AE | Pulse (act/pas) | Indication of the jumper position for pulse output active or passive. | R/W | Enum | 2048 |
ucAktuellVariante | 40B0 | Actu. Variant | The present factory-made for pulse output and communication. it can be identified by the order. | R/W | Enum | 2048 |
ucSchalteingangTest | 40B2 | Contact input | The status condition of the contact input can be viewed on or off. | R/W | Enum | 2048 |
ucSchaltausgangTest | 40B4 | Contact output | The test function contact ouput and with ENTER the function can be switched to on or off: | R/W | Enum | 2048 |
ucDlrArt_LNS | 403B | EPD Mode | Selection of the function standard or new adjustment. At standard is isn't required to carry out a adjustment on side. The converter use standard adjustment datas. If it comes to disturbances through the medium or an empty pipe isn't recognized by the converter, a new adjustment must be carried out on side, see adjustment empty pipe or full pipe. | R/W | Enum | 2048 |
Name | ID | Label | Description | Type | Access | Class |