Variable Name: mounting_type

Variable ID: 0x401B

Variable Label: Mounting Type

Variable Help: Mounting configurations will affect probe types in different ways. A sensor mounted on a nozzle whose length is greater than its width could cause a reduced signal capacity which must be accounted for by the MT5xxx. The MOUNTING TYPE corresponding to the installation must be entered correctly. The MOUNTING TYPE should fall into one of the categories listed below: PLATE - a flat surface roof or metal disk used for signal launch COUPLING PLATE - a coupling or nipple fitting welded to a flat ceiling or launch plate. NOZZLE/FLANGE H>S - A nozzle with a greater height than diameter. NOZZLE/FLANGE H<S - A Nozzle with a lesser height than diameter. STILLING WELL - a continuous metal pipe from the process connection to the end of the measuring range. EXT. CHAMBER - an external metal chamber with side connections. 2WARNING - Adjustment of this parameter may disturb settings in your Extended Parameters. Please verify Extended Parameters are set correctly for the application.

Variable Handling: R/W

Variable Class: Device

Variable Size: 1

Variable DataType: Enum

Variable Enum Value	Variable Enum Text
0x0000	Plate
0x0001	Coupling/Plate
0x0002	Nozzle/Flange H>S
0x0003	Nozzle/Flange H<S
0x0004	Stilling Well or External Chamber

Variable Display Format:

Variable Edit Format:

Variable Unit:

Variable Max: N/A

Variable Min: N/A

Variable Read Command List

Command Number	Command ID	Command Name
151	4075	read_basic_device_setup

Variable Write Command List

Command Number	Command ID	Command Name
152	4076	write_probetype_mounting_config_flags